To
use it, pull the multifunction lever toward you. When you do:
0
If
your headlamps are
off
your high beam headlamps will turn on.
They'll stay on as long as
you
hold the lever there. Release the lever to
turn them
off.
0
If
your headlamps are already on low beam, the system works
normally. Just pull the lever. Your headlamps
will
shift to high beam
and stay there.
To
return to low beam just pull the lever toward you.
If
your headlamps are already on high beam, your headlamps
will
switch to low beam.
To
get back to high beam pull the lever toward
you.
Windshield Wipers
WIPER:
To control the wipers turn the band on the multifunction lever.
MIST:
Turn the band toward you and then release it for a single wipe
cycle. For more cycles hold the band on
MIST
longer.
LO
or
HI:
Turn the band away from you to either
LO
(low speed) or to
HI
(high speed), depending on the wiper speed
you
want.
DELAY:
With this you can set the wiper speed for a long or short delay
between wipes. Move the band to the
DELAY
position. The closer you
move it to
LO
the shorter the delay.
2-4
1
To Next Page
Loading...
