3.
Decide which one of the three channels you
want
to program. Using
both hands, press the hand-held transmitter button and the desired
button on the HomeLink
TM
Transmitter. Continue
to
hold both
buttons through Step
4.
4.
Hold down both buttons
until
you see the red light on the HomeLink
Transmitter flash rapidly. The rapid flashing, which could take
up
to
90
seconds, indicates that the HomeLink
TM
Transmitter has been
programmed.
Release
both
buttons once the light starts
to
flash rapidly.
If you have trouble programming the HomeLink
TM
Transmitter, make
sure that
you
have followed the directions exactly as described and that
the
batteries
in
the hand-held transmitter are not dead.
If
you still cannot
program
it,
rotate your hand-held transmitter end over end and
try
again.
The
HomeLink
TM
Transmitter
may
not
work
with
older garage door
openers that do not meet current Federal Consumer Safety Standards. If
you cannot program the transmitter after repeated attempts, consult your
Cadillac dealer or call
1-800-355-35 15.
Be sure to keep your original hand-held transmitter
in
case
you
need
to
erase and reprogram the HomeLink
TM
transmitter.
Note
to
Canadian
Owners:
During programming, your hand-held
transmitter
may stop transmitting after one or
two
seconds.
If
you are programming
from one
of
these transmitters, the HorneLink
TM
indicator light may prompt
you to re-activate your hand-held transmitter
with
a series
of
double blinks.
After you reactivate your hand-held transmitter, the HolneLink
TM
light
should flash rapidly. If
it
flashes slowly, continue to periodically rc-activate
your hand-held transmitter
until
the
light flashes
rapidly.
Operating
the
Transmitter
Press the appropriate
button
on
the HomcLink
TM
Universal Transmitter.
The
red light comes
on
while the signal is being transmitted.
Note that the effective transmission range
of
the HomeLink" Transmitter
may differ from your hand-held transmitter and from one channel to another.
Erasing Channels
To
erase all three programmed channels, hold down
the
two outside
buttons until the red light begins
to
flash. Individual channels cannot be
erased,
but
can be reprogrammed using
the
procedure for programming
the
transmitter explained earlier.
2-66
To Next Page
Loading...
