FAN
SPEEDS
c
Press the fan symbol
button until
AUTO
is
displayed
on
the
screen.
*
At this setting, the fan speed is controlled automatically.
If it
is
cold outside, the blower may not run
in
the maximum high fan
speed right away. The system checks the temperature
of
the coolant
to
assure it is warm enough to provide heat. When the coolant is warm, the
controller allows the fan to gradually increase
to
a higher speed. This
prevents cold air from blowing
into
the passenger compartment.
If
you want the blower fan to run only at a fixed high speed, press the
(upper) button until you see
HI
on the display.
If you want the fan speed
to
be automatic, but you like the fan speed to be
higher than the
AUTO
setting, just press the fan button until
HI/AUTU
is
shown
on
the display.
If you want the blower
to
run
only
at a fixed low speed, press the (lower)
button until
LO
is shown on the display.
If you want the fan speed to run lower than the
AUTO
setting, press the
button until
AUTO
LO
is shown
on
the display.
DEFROSTER
Press this button to
remove
fog
or frost
from the windshield.
This setting sends most
of
the airflow to the windshield with only a small
amount to the floor outlets.
The fan speed will work automatically to maintain your requested interior
temperature.
If
you need more air directed to your windshield, you should
select a higher fan speed.
3-5
To Next Page
Loading...
