WIPER
BLADE
REPLACEMENT
To
replace the entire wiper blade, follow these steps:
1.
Position the windshield wipers on the windshield
in
the “mid” wipe
position.
To
do
this,
turn
the ignition key
to
ACCESSORY
and turn
the wipers
on.
Then with the door open, turn the ignition
key
to OFE
“I
I
1
2.
Insert
the
tip
of
a small screwdriver into the slot as shown and gently
press down
to
release the wiper blade from the arm.
3.
To
install the wiper blade, align the wiper arm pin with the
hole
on
the
wiper blade assembly and snap
it
into place. Return the wipers to their
normal position.
If
you only want to replace the wiper insert, follow these steps:
1.
Position the windshield wipers
on
the windshield
in
the “mid” wipe
position.
To
do this, turn the ignition key
to
ACCESSORY
and
turn
the wipers on. Then with the door open, turn the ignition key to
OFF.
2.
Insert the tip
of
a small screwdriver into the slot as shown and gently
3.
Insert
a
small coin between the edge
of
the blade housing and the
press down to release the wiper blade from the arm.
rubber blade insert.
4.
Carefully apply pressure until the insert clears one side
of
the housing tabs.
5.
Now pull the insert from the blade housing.
6-4
1
To Next Page
Loading...
