Finding a Station
SCAN:
When
you
press this button, the
SCAN
indicator in the display will
light and the radio
will
find the next station and stay there for about five
seconds. Then
it
will
go
to the next station and pause, and keep doing that
until you press either the
SCAN
button again or the upper knob.
SEEK
This button selects stations, but it doesn’t keep moving
as
SCAN
does. When you press
SEEK
the
radio
will
automatically
go
to the next
station and stay there.
Pushbuttons:
You
can
set
the
pushbuttons to get up
to
10
favorite stations
(five on
FM
and five more
on
AM.)
1.
Choose either
AM
or
FM.
2.
Tune
in
a
desired station.
3.
Press
the
SET button.
4.
Press
one
of the
five
pushbuttons
within
five seconds.
5.
Repeat these steps for each
of
the
five
pushbuttons.
Setting the Tone
BASS:
The slide control increases
or
decreases
the
bass
response tone.
Moving the control to the right increases bass
while
moving it to the left
decreases
it.
TREBLE:
The
slide control increases or decreases the treble response
tone. Moving the control
to
the right increases
the
treble while moving it
to
the
left
decreases
it.
Your
Cassette Tape Player
Your
cassette tape player works best with tapes that are
30
to
45
minutes
long
on each side. Tapes longer than that are
so
thin that they may not
work well
in
this player.
If
you
look
at the tape,
or
on
its label
or
box,
it should say whether its bias,
or
“equalization,”
is
70
microseconds
(70
p)
or
120
microseconds
(120
p).
Chrome and metal tapes are
70
p
sec and standard iron tapes
are
120
p
sec. Your tape player
will
adjust automatically
for
either type
of
cassette tape.
3-16
To Next Page
Loading...
