Need help?Do you have a question about the CAE LearningSpace and is the answer not in the manual?
Unpack the CAE LearningSpace Connect Server from its packaging and set it up.
Connect an Ethernet cable from the institution network to Port 1 on the server.
Connect your client computer to Port 2 (A/V network) for initial setup.
Steps to configure the CAE LearningSpace Connect Server as a MASTER.
Steps to configure the CAE LearningSpace Connect Server as a SLAVE.
Notes on proceeding after network setup, including initial settings configuration.
Guide to activating the CAE LearningSpace software online.
Instructions for activating the software offline by contacting support.
Navigate to the login page after software activation.
Enter default email and password for the initial login.
Change default admin email, password, and location.
Save settings and proceed to the system's home page.
Connect CAE simulators wirelessly using a Simulator Bridge.
Connect CAE simulators via a wired connection using a Simulator Bridge.
Connect third-party simulators using display capture technology.
To Next Page
General