1
Hi Flow Stroller Technical Service Manual • PN 14314465 Rev F
6
Hi Flow Stroller
Safety
V
WARNING: Medical electrical Equipment needs special precau-
tions regarding EMC and needs to be installed and put into service
according to the EMC information provided in this manual.
WARNING: Portable and mobile RF communications equipment
can affect Medical Electrical Equipment.
Table 1
Guidance and Manufacturer’s declaration—electromagnetic emissions
The Hi Flow is intended for use in the electromagnetic environment specified below. The customer or the user of the Hi Flow should
assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment—guidance
RF emissions Group 1 The Hi Flow uses RF energy only for internal function.
CISPR 11 Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
RF emissions CISPR 11 Class B
Harmonic emissions The Hi Flow is suitable for use in all establishments,
IEC 61000-3-2 Not applicable including domestic establishments and those directly connected to
Voltage fluctuations/ the public low-voltage power supply network that supplies
flicker emissions Not applicable buildings used fordomestic purposes.
IEC 61000-3-3
WARNING: The use of Accessories, transducers, and cables other
than those specified by the manufacturer may result in increased
Emissions or decreased immunity of the Hi Flow.
WARNING: The Hi Flow should not be used adjacent to or stacked
with other equipment, and that if adjacent or stacked use is neces-
sary, the Hi Flow should be observed to verify normal operation in
the configuration in which it will be used.
To Next Page
Loading...
