2012 Portable Spa
LTR20121001, Rev. A
Operating Your Spa
www. c a l s p a s. c o m
19
--For C Temperature unknown After the pump has been running for two minutes,
the temperature will be displayed.
- - - - - - Temperature not current in Economy or
Sleep mode.
In Economy or Sleep mode, the pump may be off for
hours outside a lter. If you wish to see the current
spa temperature, either switch to Standard mode or
turn Jets1 on for at least two minutes.
BUF Internal problem detected. Repair required. Contact your dealer or service
organization.
Stby Standby Mode has been activated by
pressing a button combination on the
user panel.
Press any button to leave Standby Mode and return
to normal operation.
SF Safety Suction. Spa is shut down. The display will show “SF” when a
vacuum switch closes. All functions will turn off and
the system will be disabled until a panel button is
pressed.
Periodic Reminder Messages
Press the “Mode” button to reset a displayed reminder)
Message Frequency Action Required
rPH Every 7 days Test and adjust chemical levels per manufacturer’s instructions.
rSA Every 7 days Test and adjust chemical levels per manufacturer’s instructions.
rCL Every 30 days Remove, clean, and reinstall lter per manufacturer’s instructions.
rtg Every 30 days Test & reset GFCI per manufacturer’s instructions. Drain and rell spa per
manufacturer’s instructions.
rdr Every 90 days Drain and rell spa per manufacturer’s instructions.
RCO Every 180 days Clean and condition spa cover
RCH Every 365 days Install New Bio-Clean™ Filter
To Next Page
Loading...
