Cal Spas F 1239 - Chlorine Clear Water Plan; Ozonator Clear Water Plan

2012 Portable Spa
LTR20121001, Rev. A
Water Quality Maintenance
www. c a l s p a s. c o m
27
Chlorine Clear Water Plan
Ozonator Clear Water Plan
This plan and its chemical dosages are intended for
spas equipped with the optional ozonator.
Start Up
Follow the Spa Start Up procedures for Chlorine 1.
“Clear Water Plan”.
Note: Filtration time may need to be increased with
heavy bather load.
Day One (Monday)
Test spa water using chlorine “Test Strips”. (You 1.
will need to use a small amount of chlorine as a
supplemental sanitizer.)
Based on the Test Strip readings:2.
First adjust total alkalinity (acceptable range •
of 80-120 ppm),
Then adjust the pH if needed. (Range is •
between 7.2 to 7.8.)
Add 1 tablespoon of Chlorine Granules.•
The recommended level of Chlorine is 1-3 •
ppm.
Add 2 oz of “Stain and Scale Defense”.3.
Remove dirty lter from the spa and rinse off.4.
Place your extra clean lter cartridge back into 5.
the spa.
Vacuum debris from the bottom of your spa with 6.
the “Spa Vacuum”.
Day Two (Friday)
Test spa water using Chlorine Test Strips.1.
Based on the Test Strip reading: 2.
Adjust total alkalinity, then the pH if needed. •
Add 1 tablespoon of Chlorine Granules (if •
needed).
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15 3.
minutes with cover off.
Replace cover.4.
Day One (Monday)
Test spa water using “Chlorine Test Strips”.1.
Based on the Test Strip readings:2.
First adjust total alkalinity (acceptable range •
of 80-120 ppm)
Then adjust the pH if needed (range is •
between 7.2 to 7.8).
Add 2 tablespoons of Chlorine Granules.•
The recommended level of Chlorine is 3-5 •
ppm.
Add 2 oz of “Stain and Scale Defense”.3.
Remove dirty lter from the spa and rinse off.4.
Place your extra clean lter cartridge back into 5.
the spa.
Vacuum debris from the bottom of your spa with 6.
the “Spa Vacuum”.
Day Two (Wednesday)
Test spa water using Chlorine Test Strips.1.
Based on the Test Strip reading: Adjust total 2.
alkalinity, then the pH if needed.
Day Three (Friday)
Test spa water using Chlorine Test Strips.1.
Based on the Test Strip reading: 2.
Adjust total alkalinity, then the pH if needed. •
Add 2 tablespoons of Chlorine Granules (if •
needed).
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15 3.
minutes with cover off.
Replace cover.4.