Cal Spas F 1239 - Page 37

2012 Portable Spa
LTR20121001, Rev. A
Cleaning and Maintenance
www. c a l s p a s. c o m
34
All-Purpose Cleaner (Spa nish
cleaning)
All-Purpose Cleaner is an essential part of maintaining
your spa’s nish. Through normal use, the spa’s nish
can accumulate dirt, oil, and calcium causing a rough
feel and unsightly scum lines. All-Purpose Cleaner
is a low detergent, non-abrasive cleaner specically
formulated to clean the spa without damaging its
acrylic nish.
The most effective solution to minimize cleaning time
is prevention. When the following steps are followed,
the spa’s nish will actually start to resist most of the
elements that cause calcium build-up and make scum
line clean up easier.
Prior to Spa Start-Up and Relling
Spray Multi-Purpose Cleaner directly on to the 1.
spa’s nish.
Wipe clean with a clean soft cloth.2.
Repeat on heavily calcied areas.3.
Wipe spa thoroughly with a wet sponge, rinsing 4.
often with a bucket of clean water.
Allow spa to dry completely.5.
Apply a coat of Fast Sheen to the spa’s entire nish 6.
with a soft towel or sponge.
Allow Fast Sheen to dry until white and powdery.7.
Buff clean with a soft cloth, rotating frequently.8.
Periodic Maintenance
Spray Multi-Purpose Cleaner directly to the spa’s 1.
nish.
Wipe clean with a clean soft cloth.2.
Wipe spa thoroughly with a wet sponge, rinsing 3.
often in a bucket of clean water.
Multi-Purpose Cleaner should not be sprayed directly
into the spa water. Incorrect usage of this product will
cause water clarity issues.
Fast Sheen (Spa nish protecting wax)
Fast Sheen is an essential part of maintaining your
spa’s nish. Through normal use, the spa’s nish can
accumulate dirt, oil, and calcium, causing a rough feel
and unsightly scum lines. Fast Sheen is a non-oil based
wax that is specically formulated to protect the spa’s
nish from the chemicals and minerals associated with
normal spa use.
The most effective solution to minimize cleaning time
is prevention. When the following steps are followed,
the spa’s nish will actually start to resist most of the
elements that cause calcium build-up and make scum
line clean-up easier.
Prior to Spa Start-Up and Relling
Spray Multi-Purpose Cleaner directly to the spa’s 1.
nish.
Wipe clean with a soft cloth.2.
Repeat on heavily calcied areas.3.
Wipe spa thoroughly with a wet sponge, rinsing 4.
often in a bucket of clean water.
Allow the spa to dry completely.5.
Apply a coat of Fast Sheen to the spa’s entire nish 6.
with a soft cloth or sponge.
Allow Fast Sheen to dry until white and powdery.7.
Buff clean with a soft cloth, rotating frequently.8.
IMPORTANT: Fast Sheen should not be used on spas
full of water. Only apply to clean, cool, dry surfaces.
Incorrect product usage may cause water clarity
issues.