U
SER’S GUIDE — 25
Memory Storage Keys (M0-M5)
In addition to the standard cumulative Memory (as described above),
your calculator has six independent Storage Registers — M0
through M5 — that can be used to permanently store single, non-
cumulative values. These values will be held when your calculator is
turned off, and will only clear when a “Clear All” is performed (via
s x).
You can replace a value in one of these Memory registers by storing
a new value in place of the stored value.
FUNCTION KEYSTROKES
Store single value in M0 s ® 0
Store single value in M1 s ® 1
Store single value in M2-M5 s ® 2, 3, 4 or 5
Clear register (e.g., M1) 0 s ® 1
Review stored value (e.g., M1) ® 1
Clear stored value* s x
*Perform a s x (Clear All) with caution, as it will clear any stored values from your
calculator’s registers.
Example:
Store 175 into M1, recall the value, and then store a new value in
place of the first stored value:
STEPS KEYSTROKES DISPLAY
Store value in M1 1 7 5 s ® 1 M-1 175.00
Turn off, and then turn on O o 0.00
Recall value stored in M1 ® 1 M-1 175.00
Replace stored value with
new value 1 5 0 s ® 1 M-1 150.00
To Next Page
Loading...
