EasyManua.ls Logo

Calculated Industries Dimension Master Plus - Device Features; Measurement Units and Aim Assist; Display, Auto-Shutoff, and Error Messages

Calculated Industries Dimension Master Plus
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
³'
,0(16,21
0
$67(5
3
/86
Feet/Inch or Metric Switch
For your convenience, a switch on the left side of
the unit allows you to set the measurement mode to
either the English/Imperial Feet-Inch (F/I) system
or to the Metric (Met) system.
Aim Assist
Pointer Lamp
The Aim Assist
pointer lamp is designed for
many years of service under normal operation.
Should the bulb burn out, please contact the manu-
facturer for replacement details.
Display Accuracy
The Dimension Master Plus has an eleven-digit
display. This is made up of seven digits for the
normal display and four digits for the fractional
display. In a standard calculation, the calculation is
carried out to a 10-digit internal accuracy, and then
rounded to a 7-digit standard display using a 5/4
rounding.
Automatic Shutoff
The Dimension Master Plus is designed to shut it-
self off after approximately 7 minutes of non-use.
Any value shown on the display is cleared at this
point. All values stored in the memory registers re-
main unchanged.
None/Error Messages
If the Dimension Master Plus is unable to measure
a distance, two beeps sound and either the word

Related product manuals