EasyManuals Logo

Calculated Industries Machinist Calc Pro 4087 User Manual

Calculated Industries Machinist Calc Pro 4087
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Us e r 's GU i d e 67
Auto-Range If an “overflowis created because of an
input and calculation with small units that are out of the stan-
dard eight-digit range of the display, the answer will be auto-
matically expressed in the next larger units (instead of show-
ing OFLO”) e.g., 200,000,000 mm is shown as 200,000
m. Also applies to inches and feet.
auTO SHuT-OFF
Your calculator is designed to shut itself off after about 8-12
minutes of non-use.
BaTTErIES
T h e Machinist Calc and Machinist Calc Pro use two LR-44
batteries. Should your calculator display become very dim or
erratic, replace the batteries.
Note: Please use caution when disposing of your old batteries, as they
contain hazardous chemicals.
Replacement batteries are available at most discount or
electronics stores. You may also call Calculated Industries at
1-775-885-4900.
Battery Replacement Instructions
To replace the batteries, slide open the battery door (at top
backside of unit) and replace with new batteries. Make sure
the batteries are facing positive side up.
rESET
If your calculator should ever “lock up,press Reset – a small
hole located above the
C
key to perform a total reset.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Calculated Industries Machinist Calc Pro 4087 and is the answer not in the manual?

Calculated Industries Machinist Calc Pro 4087 Specifications

General IconGeneral
BrandCalculated Industries
ModelMachinist Calc Pro 4087
CategoryCalculator
LanguageEnglish

Related product manuals