Calculated Industries Tradesman Calc 4400 - Page 42

Pocket RefeRence Guide — 41
At this point you must determine
what caused the error and re-key the
problem.
Error Codes
OFlO
Overow (too large)
MATH Error
Divide by 0
DIM Error
Dimension error
ENT Error
Invalid entry error
Auto-Range
If an “overow” is created because of
a calculation with small units that are
out of the standard digit range of the
display, the answer will be automatically
expressed in the next larger units
(instead of showing “OFlO”) – e.g.,
100,000,000 mm is shown as
100,000 m.
(cont’d)