CUSTOMIZING YOUR MASSAGE
Your CALDERA spa offers numerous ways for you to customize your massage experience. Experimentation is the best way to find what feels best to you. Try sitting in
different seats, adjusting the diverter valves, air controls, and jet nozzles and turning each pump on or off.
DIVERTER VALVES
The diverter valves on your spa allow you to direct the flow of water from the pumps to various combinations of jets. The functions of these diverter valves can best be
learned by experimentation as follows:
1. Set all air controls to the “ON” position by rotating counterclockwise.
2. Turn on both pumps.
3. Turn the handle on each diverter valve and see which groups of jets are affected. (Note that you can adjust the diverter valves to any position between the two
possible extremes to achieve the jet pressure that feels best to you.)
IMPORTANT: Your spa is not designed to provide full power to all jets when the diverter valves are in the “mid” position. However, with the diverter valve in this
position, you may increase the power to selected jets by rotating the face of the ADAPTAFLO and ADAPTASSAGE
jets to close the ones that are not in use.
TIP: Turn both pumps on and place the diverter valves to the “Mid-Position”. Then experiment with each of the air controls to see their effect.
ACQUARELLA
WATERFALL VALVE
The CANTABRIA, GENEVA, NIAGARA, TAHITIAN, MAKENA,
SALINA, and MARTINIQUE
are
equipped with the ACQUARELLA Waterfall feature. activated by pressing on JETS button once or
several times until waterfall begins to flow. The flow is regulated by turning the ACQUARELLA Waterfall
valve located on the inside wall of the spa.
ATLAS NECK JET VALVE
The CANTABRIA,, GENEVA and NIAGARA spas are equipped with 4 directional neck jets located in
the ECSTASEAT. The flow of the neck jets is regulated by turning the ATLAS NeckJet valve on the
inside wall of the spa.
AIR CONTROLS
Each jet system has its own air control. These allow you to change the power of the jets by regulating the amount of air that is mixed with the
water coming out of the jets.
HYDRO JETS
Note: All Hydro jet images are shown with stainless steel escutcheons.
ADAPTAFLO Jet - This jet allows you to redirect the jet stream by changing the position of the nozzle.
ADAPTASSAGE Jet - This jet provides a rotating massage pattern.
The face plates in the ADAPTAFLO jets and the ADAPTASSAGE jets are interchangeable. To remove a ADAPTASSAGE
face plate, turn it counter-clockwise until it stops turning. Turn the face once more until you hear a clicking noise. Push the
face in, and then pull it straight off. Install the face plate by snapping it into place. Additional ADAPTASSAGE dual-port
nozzles are available from your CALDERA dealer.
Position 1 - The full flow
is directed to one series
of jets.
Mid-Position -
Positioning the diverter
at any point between
position one and two
divides the flow between
the jet systems.
Position 2 - The full flow
is directed to a second
series of jets.
PARADISE SERIES
UTOPIA SERIES
PARADISE SERIES
UTOPIA SERIES
FULL
Medium
Gentle
25
UTOPIA SERIES
To Next Page
Loading...
