CALIENT S320 - SNMP Trap V3 Parameters; Figure 4 - Configuring SNMP V3 Get;Set Parameters

CALIENT OCS WebGUI Quick Start Guide
Doc. Part No. 460185-00
July 28, 2015
Rev. 0.2
Page 23 of 63
Field Name
Description
Required
Priv Protocol
Privacy Protocol; value can be
AES or DES
Yes, if Security Level
is Auth/Priv ONLY
Auth Password
Authentication Password
Yes, if Security Level
is Auth/NoPriv or
Auth/Priv ONLY
Same Password
for Auth & Priv
Flag specifying whether the
password is the same for both
Authentication and Privacy;
values can be Yes or No
Yes
Priv Password
Privacy Password
Yes, if the Security
Level is authPriv and
Same Password for
Auth & Priv is No
The SNMP v3 Engine ID and user parameters are displayed in the SNMP v3 tab under the SNMP
Configuration tab of the SNMP Configuration screen:
Figure 4 – Configuring SNMP v3 Get/Set Parameters
4.1.3.4 SNMP Trap v3 Parameters
For the SNMP v3 agent to send an SNMP v3 Trap or Inform message, a trap destination and
SNMP v3 user need to be configured. The system has a provision to import already-configured
SNMP v3 users from the SNMP v3 Get/Set configuration, but an SNMP v3 user needs to be