Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.. Page 31 of page 38
CALIX 2364 ONT INSTALLATION GUIDE
3 - 2364 ONT I
NSTALLATION
S
TEPS
3.13 Completing Your Installation
Use the following steps to complete the installation:
1. Connect the power connector to the mated socket located on the ONT electronics panel.
2. Fill the cable entry grommets with a suitable gel sealant to prevent contaminant and insect intrusion.
3. If you are using the ONT outer enclosure close the enclosure door while checking for interference and ensuring all
cables are properly positioned. Do not force the door closed.
4. Tighten the captive security hex head screw with the security tool. Do not overtighten it.
Installation of the unit is now complete. The unit is ready for service.
To Next Page
Loading...
Need help?
General