18
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Before you Begin
Before starting the installation process, check that the following conditions are met:
Ensure the site preparation steps are complete based on the model being installed.
Ensure that all components are on-site or readily available to complete the installation.
The customer is aware of your planned visit and will provide access to the inside of the
home.
Introduction
This document describes the installation of the following:
GigaSpire BLAST u4
GigaSpire Mesh BLAST u4m
The BLAST u4/u4m are designed to be placed in a horizontal table-top configuration or can
be wall mounted using the mounting holes molded into the back of the unit.
Powering Options
By attaching to any 110/220 VAC power outlet using the supplied 12 VDC wall
transformer.
Note: For all models, the power cord configuration must be appropriate for use in the
country where the device is being deployed.
Note: Only provided and approved power cords or voltage adapters should be used to
connect to this product(s).
To Next Page
Loading...
Need help?
General
