17
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
GigaSpire BLAST u4
Input voltage: 12 VDC (nominal)
10 VDC (min.), 15 VDC (max)
External Power Adapter: 12 VDC, 2 A
GigaSpire BLAST u4m
Input voltage: 12 VDC (nominal)
10 VDC (min.), 15 VDC (max)
External Power Adapter: 12 VDC, 2 A
DANGER! Using non-approved or incorrect power adapters
can result in injury.
Site Preparation
Before you install any BLAST device, you need to consider the routing of the power adapter
cord and Ethernet cable(s) if used.
Note: It is critical that you maintain the proper airflow in and around the unit. These devices
are designed for surface mounting only. Do not install cabinetry or other building material
around the outside of the unit.
Power Cords
In order to complete the installation, a power cords is required:
Connectorized Power and Signal Cable - A 2-pin barrel connector to the local AC power
receptacle (Type A).
Coaxial Cables
Note that Coaxial cable connections are to be internal connections only. Outdoor
connections are not allowed.
To Next Page
Loading...
Need help?
General
