Important safety instructions
For
your own safety please read the following
important
safety instructions carefully before
attempting
to
connect this unit to the mains
power supply. They
will
also enable you to get
the
best performance from and prolong the
life
of
the
unit:
1. Read these instructions.
2. Keep these instructions.
3. Heed
all
warnings.
4. Follow
all
instructions.
5.
Do
not use this apparatus near water.
6. Clean only with a dry cloth.
7.
Do
not block
e1ny
ventilation
open1ngs. Install
in
accordance with the manufacturer's instructions.
8.
Do
not install near
an
y heat sources such as radiators, heat registers. stoves, or other apparatus (including amplifiers) that produce
heat.
9.
Do
not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the
other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your
safety.
If
the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect
the power cord from being walked
on
or
pir
.ched, particularly at plugs, convenience receptacles and the point where they
exit from the apparatus.
11.
Only
use
attachments;
accessories specified
by
the manufacturer.
12.
Use
with only the cart, stand, tripod, bracket, or table specified
by
the manufacturer, or sold with the apparatus. When
a
cart
is used, use caution when moving the
cart;
apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer
all
servicing to
qualified service personnel. Servicing is required when the apparatus has been damaged in any
way,
such
as the power-supply cord or plug having been damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
WARNING
-To
reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.
- Batteries (battery pack or batteries
installed) shall
not be exposed to excessive
heat
such as sunshine, fire or the like.
The unit is of Class 1 construction and must
be
connected to a mains socket outlet with a protective earthing connection.
The unit must
be
installed
in
a manner
that
makes disconnection of the mains plug from the mains socket outlet (or appliance
connector from the rear
of
the unit) possible. Where the mains plug
is
used as the disconnect device, the disconnect device
shall
remain readily operable.
Only
use the mains cord
supplied
with this unit.
Please
ensure there
is
ample ventilation (at least
10cm
clearance
all
round).
Do
not put any objects on top of this unit.
Do
not
situate
it
on
a rug or other soft surface and do not obstruct any air inlets or outlet grilles.
Do
not cover the ventilation grilles with items such
as newspapers, tablecloths, curtains, etc.
This unit must not
be
used near water or exposed to dripping or splashing water or other liquids.
No
objects filled with liquid, such as
vases.
shall
be
placed on the unit.
The
lightning flash with the arrowhead symbol within an equilateral triangle is intended to alert the user to the presence
of
un-insulated
'dangerous voltage' within the product's enclosure
that
may be of sufficient magnitude to constitute a risk
of
electric shock to persons.
The
exclamation point within
an
equilateral triangle is intended to
alert
the user to the presence of important operating and
maintenance instructions
in
the service literature relevant to this appliance.
WEEE
symbol
The
crossed-out wheeled bin is the European Union symbol for indicating separate collection for electrical and electronic
equipment. This product
contams
electrical and electronic equipment
wh1ch
should be reused, recycled or recovered and
- should not
be
disposed of with unsorted regular waste.
Please
return the unit or contact the authorised dealer from whom you
purchased this
product for more information.
( €
CEmark
This product complies with European
Low
Voltage
(2006/95
/
EC),
Electromagnetic Compatibility
(2004/108/EC)
and
Environmentally-friendly design of Energy-related
Products
(2009/125/EC)
Directives when used and
installed
according to this
instruction manual.
For
continued compliance only Cambridge Audio accessories should
be
used with this product and servicing must
be
referred to qualified service personnel.
C
C-Tick
mark
This product meets the Australian Communications Authority's Radio communications and
EMC
requirements.
[ n [
CU-TR
Mark
[ This product meets Russia, Byelorussia and Kazakhstan electronic safety approvals.
FCC
regulations
NOTE:
THE MANUFACTURER
IS
NOT RESPONSIBLE
FOR
ANY
RADIO OR TV
INTERFERENCE CAUSED
BY
UNAUTHORIZED
MODIFICATIONS
TO
THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID
THE USER
AUTHORITY
TO
OPERATE
THE
EQUIPMENT.
~
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part
15
of
the
FCC
~
Rules. These limits are designed to provide reasonable protection against harmful interference
in
a residential installation.
ThiS
equipment generates, uses and can
rad1ate
rad1o
frequency energy and,
if
not installed and used in accordance with the
instructions,
may
cause harmful ir.terference to radio communications. However, there
is
no guarantee
that
interference
will
not occur
in
a particular installation.
If
this equipment does cause harmful interference to radio or television reception, which can be determined
by
turning the equipment
off
and on, the user is encouraged to try to correct the interference
by
one or more of the following measures:
-Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet
on
a circuit different from
that
to which the receiver is connected.
-Consult the dealer or
an
experienced radio/
TV
technician for help.
Ventilation
IMPORTANT -
The
unit will become hot when in use.
Do
not stack multiple units on top of each other.
Do
not place in an enclosed area
such as a bookcase or in a cabinet without suffic1ent
ventilation.
Ensure that
small
objects do not
fall
through any ventilation grille.
If
this happens, switch
off
immediately, disconnect from the mains
supply and contact your dealer for advice.
Positioning
Choose
the installation location carefully. Avoid placing it
in
direct sunlight or close to a source
of
heat.
No
naked flame sources, such
as lighted candles, should
be
placed
on
the unit. Also avoid locations subject to vibration and excessive dust, cold or moisture.
The
unit can
be
used
in
a moderate climate.
This unit must
be
installed
on
a sturdy, level surface.
Do
not place in a sealed area such as a bookcase or in a cabinet.
Do
not place
the unit on an unstable surface or shelf. The unit may
fall,
causing serious injury to a child or adult
as well
as serious damage to the
product.
Do
not place other equipment
on
top of the unit.
Due to stray magnetic fields, turntables or
CRT
TVs
should not be located nearby due to possible interference.
Electronic audio components have a running in period
of
around a week (if used several hours per day). This
will
allow the new
components to settle down and the sonic properties
will
improve over this time.
Power sources
The unit should
be
operated only from the type of power source indicated on the marking label.
If
you are not sure of the type
of
power-
supply to your home. consult your product dealer or local power company.
This unit can
be
left in
Standby
mode when not
in
use and
will
draw
<0.5W
in
this state.
If
you
do not intend to use this unit for a long
period of time, unplug it from the mains so cket.
Overloading
Do
not overload
wall
outlets or extension cords as this can result
in
a risk
of
fire or electric shock. Overloaded
AC
outlets, extension
cords. frayed power cords, damaged or cracked wire insulation and broken plugs are dangerous. They may result
in
a shock or fire
hazard.
Be
sure to insert each power cord securel
y.
To
prevent hum and noise. do not bundle the interconnect leads with the power cord or
speaker leads.
Cleaning
To
clean the unit, wipe its case with a dry, lint-free cloth.
Do
not use any cleaning fluids containing alcohol, ammonia or abrasives.
Do
not spray an aerosol at or near the unit.
Battery
disposal
Batteries may contain substances harmful to the environment.
Please
dispose of any discharged batteries with due consideration and
in
accordance with local environmental/electronic recycling guidelines.
Servicing
These units are not user serviceable. Never attempt to repair, disassemble or reconstruct the unit if there seems to
be
a problem. A
serious electric shock could result if this precautionary measure is ignored.
In
the event
of
a problem or failure, please contact your
dealer.
To Previous Page
Loading...
