Page 3 - Manual FA01810-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
GENERAL PRECAUTIONS FOR INSTALLERS
Important safety instructions.
Please follow all of these instructions. Improper installation may cause serious
bodily harm.
Before continuing, please also read the general precautions for users. •
Only use this product for its intended purpose. Any other use is hazardous. •
The manufacturer cannot be held liable for any damage caused by improper,
unreasonable or erroneous use. • This product is defi ned by the Machinery Directive
(2006/42/EC) as partly completed machinery. • Partly completed machinery means
an assembly which is almost machinery but which cannot in itself perform a specifi c
application. • Partly completed machinery is only intended to be incorporated into or
assembled with other machinery or other partly completed machinery or equipment
thereby forming machinery to which the Machinery Directive (2006/42/EC) applies.
• The fi nal installation must comply with the Machinery Directive (2006/42/EC) and
the European reference standards in force. • The manufacturer declines any liability
for using non-original products, which would also void the warranty. • All operations
indicated in this manual must be carried out exclusively by skilled and qualifi ed
personnel and in full compliance with the regulations in force. • The device must
be installed, wired, connected and tested according to good professional practice,
in compliance with the standards and laws in force. • All the components (e.g.
actuators, photocells and sensitive edges) needed for the fi nal installation to comply
with the Machinery Directive (2006/42/EC) and with the reference harmonised
technical standards are specifi ed in the general CAME product catalogue or on the
website www.came.com. • Make sure the mains power supply is disconnected
during all installation procedures. • Check that the temperature ranges given are
suitable for the installation site. • Do not install the operator on surfaces that could
yield and bend. If necessary, add suitable reinforcements to the anchoring points.
• Make sure that no direct jets of water can wet the product at the installation site
(sprinklers, water cleaners, etc.). • Make sure you have set up a suitable dual-pole
cut-o device along the power supply that is compliant with the installation rules.
It should completely cut o the power supply according to category III surcharge
conditions. • Demarcate the entire site properly to prevent unauthorised personnel
from entering, especially minors. • In case of manual handling, have one person
for every 20 kg that needs hoisting; for non-manual handling, use proper hoisting
equipment in safe conditions. • Use suitable protection to prevent any mechanical
hazards due to persons loitering within the operating range of the operator.
To Next Page
Loading...
Need help?
General
