CAME G4000 - Wiring Connections for Buttons and Sensors; Pushbutton and Radio Connections; Safety Contact Connections; Microswitch and Antenna Connections

Page 16 - Manual FA01560-EN - 02/2023 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Correct the boom’s vertical position
Release the gearmotor.
Open the inspection hatch.
1
Turn the mechanical stop until you reach the desired boom position.
2
Fasten the mechanical stop with a locknut.
Lock the gearmotor
+
_
~1°
1
1
2
~89°