Need help?Do you have a question about the CAME G6000 and is the answer not in the manual?
General| Brand | CAME |
|---|---|
| Model | G6000 |
| Category | Control Systems |
| Language | English |
Identifies primary risks and hazards associated with the barrier's operation.
Instructions for safely dismantling and responsibly disposing of the product and its packaging.
Details on different barrier models, their intended use, and limitations.
Comprehensive technical data, operating parameters, and fuse requirements for all models.
Steps for preparing the installation site, including foundation and conduit setup.
Guide for correctly installing the anchoring plate into the foundation.
Procedures for physically mounting the boom onto the barrier mechanism.
Selection criteria for balance spring attachment points based on passage width.
Procedure to set the correct horizontal end-stop positions for the boom.
Guidelines for routing cables, connecting power, and accessory outputs.
Information on connecting accessories and their maximum power capacity.
Details for wiring various command and control devices to the barrier.
Setting up additional lights, flashing beacons, and status warning lights.
Instructions for connecting and configuring safety devices, focusing on photocells.
Various connection modes for DIR/DELTA-S photocells, including standard, sleep, and safety test.
Various connection modes for DXR/DLX photocells, including standard, sleep, and safety test.
Explains control button functions and initial steps for programming the barrier.
Overview of the functions menu and how to configure inputs like CX and CY.
Configuration of safety tests, operation modes, and warning light settings.
Adjustments for sensor types, flashing rope lights, and light outputs.
Settings for automatic closure, pre-flashing, operating, and courtesy times.
Adjustments for opening/closing speed, slowdown, calibration, and travel sensitivity.
Settings for slowdown sensitivity, RSE, data saving/reading, and system parameters.
Configuration for sleep mode, CRP address, and master-slave system setup.
Setting RSE communication speed and managing user registrations.
Configuration for different types of radio transmitter coding.
Restoring factory settings and viewing the operational manoeuvre count.
Checking firmware and transferring configuration data via memory devices.
Connecting and programming two operators for synchronized control.
Procedures for saving users and selecting basic operating modes.
Wiring and programming for configuring alternate barrier operation.
Detailed sequences for opening commands on barriers A and B in paired/alternate modes.
List of error codes and their meanings for diagnosing issues.
Guidelines for regular maintenance, checks, and understanding Mean Cycles Between Failures.
To Next Page
