To Next Page
V
Virginia BarronAug 19, 2025
What to do if CAME Control Systems photocells do not work?
- WwilliamsmichaelSep 12, 2025
If the photocells aren't working, check the opening endstop.
What to do if CAME Control Systems photocells do not work?
If the photocells aren't working, check the opening endstop.
What to do if CAME G4040IZ Control Systems barrier boom opens but does not close?
If the boom opens but doesn't close, try deactivating the MAINTAINED ACTION function.
What to do if my CAME G4040IZ barrier does not work with the transmitter?
If the barrier isn't responding to the transmitter, deactivate the MASTER-SLAVE function.
What to do if CAME Control Systems boom closes but does not open?
If the boom closes but doesn't open, check the power supply and fuses.
Why is my CAME G4040IZ Control Systems barrier not automatically closing?
If the barrier isn't closing automatically, it could be because the NC contacts are open.
Why is the warning LED flashing quickly on my CAME G4040IZ?
If the warning LED is flashing quickly, check the closing endstop.
Why does my CAME G4040IZ boom starts slow?
If the boom starts slow, you can try several solutions: - Memorize the radio code again - Adjust the sensitivity - Enter or duplicate the same code on all transmitters - Activate the photocells - Connect the photocells serially instead of in parallel fashion - Check the batteries - Respect the photocell's power supply polarities
What to do if CAME Control Systems boom's direction of travel is inverted?
If the boom's direction seems inverted, check the boom's balancing and spring tautness.
What to do if only one transmitter works with my CAME Control Systems?
If only one transmitter is working, try deactivating the OBSTRUCTION DETECTION function.
What to do if CAME G4040IZ Control Systems boom does not reach the endstop?
If the boom isn't reaching the endstop, check the proper direction of travel.
General| Brand | CAME |
|---|---|
| Model | G4040IZ |
| Category | Control Systems |
| Language | English |
