CAME G5000 - Barrier Configuration (Left;Right); Inverting Opening Direction; Adjusting Stops and Motor Phase

180°
90°
M N M N
p. 11 - Manual FA00571-EN v. 1 - 08/2017- © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice.
⚠
The barrier is set up for installing on the left.
If installing on the right side, invert the opening direction, in the following way:
- release the gearmotor, loosen the screws from the rods ❶;
- remove the transmission lever from the lever arm ❷;
- free up the lever arm from the drive shaft by removing the screws and elastic
dowels ❸;
- turn the lever arm 90° counter clockwise ❹;
- fasten the lever arm to the drive shaft by refitting the screws and dowels ❺;
- remove the mechanical closing stop and fit it into the opposite side ❻;
- remove the opening mechanical stop, turn it 180° and fasten it (locking torque
of 77.5 Nm) ❼;
- refit the transmission lever to the lever arm (locking torque of 77.5 Nm)) ❽;
-lock the gearmotor and turn the screws onto the rods ❾;
- from the control panel, invert gearmotor phase M to N ❿.
LEFT RIGHT
①Brown
②Blue