CAME G5000 - Paired Operation Setup; System Configuration for Paired Mode; Operating Modes in Paired Operation

MASTER
SLAVE
MASTER
SLAVE
MASTER
SLAVE
p. 31 - Manual FA00571-EN v. 1 - 08/2017- © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice.
PAIRED OPERATION
Important! Start by doing the following on both barriers:
- Fit the RSE card into the connector on the control panel of both operators.
- connect the two control panels via a CAT 5 type-cable (max 1,000 m) to terminals A-A / B-B / GND-GND, see paragraph on CON-
NECTING FOR PAIRED OR ALTERNATE OPERATING MODE.
- connect all of the control and safety devices to the MASTER control panel.
Important! Deactivate function F 19 (automatic closing time) on the SLAVE barrier's control panel.
Memorizing
Run the user entering procedure with the OPEN ONLY and PEDESTRIAN / PARTIAL OPENING command on the MASTER panel.
Confi guring the MASTER operator
Select function F 49. Press ENTER to confi rm.
Select 1 (paired) and press ENTER.
Transferring parameters from MASTER to SLAVE
Select function F 52 on the MASTER control panel.
Select 1 and press ENTER.
Programming
On both barriers, set the following functions:
- setting the boom type (A1);
- the motor test (A2);
- total stop (F1);
- travel calibration (A3).
Carry out any settings and adjustments on the MASTER control panel.
Operating modes
 STEP-STEP or OPEN ONLY command. Both booms open.
 PARTIAL OPENING/PEDESTRIAN command. Only the MASTER barrier opens.
For the types of command that can be selected and paired to users, see the ENTERING USERS WITH ASSOCIATED COMMANDS.