CAME KRONO KR300 Installation Manual

CAME KRONO KR300

16 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

KRONO SERIES

INSTALLATION MANUAL

KR300 - KR310 - KR510

AUTOMATION FOR SWING GATES

E

ng

li

s

h

EN

Table of Contents

Other manuals for CAME KRONO KR300

Installation Instructions32 pages

Questions and Answers:

Z
Zachary RodriguezAug 2, 2025
Why CAME Gate Opener won't respond to remote control?
- E
  Emily MorganAug 2, 2025
  If your CAME Gate Opener isn't responding to the remote, there are several potential causes: * The AF frequency card may not be fitted to the control panel. * The remote control may not be programmed into the control panel. * The remote control might have the wrong code setting. * 'Operator Present' might not be selected, deactivating radio remote controls (check DIP switch 1). * The wrong frequency card may be fitted for the remote control.
V
victoria65Aug 10, 2025
How to fix CAME KRONO KR300 that won't respond to a command?
- M
  Mr. Stephen Riley DVMAug 10, 2025
  If your CAME Gate Opener isn't responding to commands, try these checks: 1. Verify the power supply to the control panel. 2. Inspect the control panel fuses. 3. Check the hard wire link fitted between terminals 1 & 2. 4. Confirm that capacitors are fitted and wired correctly.
G
Gabrielle JohnsonAug 17, 2025
What to do if CAME KRONO KR300 Gate Opener is open but won't close and the green LED is flashing?
- S
  sarahmarshallAug 17, 2025
  If your CAME Gate Opener is open but won't close and the green LED is flashing, consider the following: 1. Check that the safety beams are wired correctly. If multiple sets of beams are installed, ensure they are wired in series. 2. Confirm that there is power going to the beams; if not, restore power. 3. If safety beams are not fitted, ensure a hard wire link is fitted between terminals 2 & C1. 4. Remove safety beam wires 2 & C1 from the control panel and check for a normally closed circuit coming from the beams.
M
mezakarenAug 25, 2025
Why CAME KRONO KR300 automatically opens but does not automatically close when commissioning?
- N
  Nancy HunterAug 26, 2025
  If your CAME Gate Opener automatically opens but doesn't automatically close during commissioning: 1. Check the motor wires. They might be the wrong way round. Prove motor direction by momentarily pulsing terminals 2 & 3; the gate should open. 2. Turn automatic closing off (DIP switch 2) until motor direction has been proven.

CAME KRONO KR300 Specifications

General

Power Supply	230 V AC
Motor Power	150 W
Max Gate Weight	800 kg
Operating Temperature	-20°C to +55°C
Motor Voltage	230 V AC
Power	300 W
Thrust	3000 N
Protection Level	IP54
Maximum Leaf Width	3 m
Protection Rating	IP54
Max Gate Length	3 m
Maximum Leaf Weight	400 kg
Safety Features	Obstacle detection

Related product manuals

CAME KRONO KR310

Preview: CAME KR300

Preview: CAME ATI KIT

Preview: CAME FROG-P KIT

CAME FROG-P KIT

Preview: CAME FROG

Preview: CAME FROG-A

Preview: CAME FAST 70

Preview: CAME BK Series

Preview: CAME OPS series

CAME OPS series

CAME BKV Series

Preview: CAME FROG series

CAME FROG series

CAME FERN Series