CAME VER Series Installation Manual

{
{
{
- - -
v
DFW
Page 22 - Manual FA01176-EN - 02/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Sensitive Safety Edges
Confi gure contact CX, CY (NC), safety input for sensitive safety-edges.
See functions for input CX (Function F 2) or CY (Function F 3) in:
- C7 reopening while closing (NC input). When the door is closing, opening the contact causes the door to invert
its movement immediately until it is completely open;
- r7 opening again during closing (8K2 resistive input). When the door is closing, opening the contact causes the
door to invert its movement immediately until it is completely open;
 If unused, contacts CX and CY should be deactivated during programming.
The ESC button is for:
- exiting menus;
- deleting changes;
- STOPPING when the
motor is moving.
The ENTER key is for:
- accessing menus;
- confi rming or memorizing set values.
The < > keys are for:
- moving from one item to another;
- increasing or decreasing a value;
- < CLOSE command;
- > OPEN command.
Display
Description of programming commands
To enter the menu, keep the ENTER key pressed for one
second.
To exit the menu, wait 20 seconds or press ESC.
Browsing the menu
 When the menu is active, the system cannot be used.
p. 22 -
Manual
FA01176-EN - 02/2019 - © CAME S.p.A. -
The contents of this manual may be changed, at any time, and without notice. - Original instructions

CAME VER Series Specifications

General

Brand	CAME
Model	VER Series
Category	Garage Door Opener
Language	English