i
u
8
2
FA
❶ ❷ ❸
Page 27 - Manual FA01176-EN - 02/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Entering a user with an associated command
N.B.: when entering and deleting users, the numbers that appear fl ashing are available and usable
numbers for entering new users (max. 250 users).
Select U1. Press ENTER to confi rm
❶.
Select a command to associate to the user.
The commands are:
1 = step-step (open-close);
2 = - sequential (open-stop-close-stop);
3 = open;
4 = partial opening.
Press ENTER to confi rm
❷.
An available number between 1 and 250 will fl ash for a few seconds. This number will be assigned to the user
after sending the code through the transmitter
❸.
⚠
Before fi tting the snap-in cards, you
MUST CUT OFF THE MAINS POWER SUPPLY.
To enter, change and delete user or to control
the operator via the radio command, fi t the
AF card.
Transmitter and Saving users
p. 27 -
Manual
FA01176-EN - 02/2019 - © CAME S.p.A. -
The contents of this manual may be changed, at any time, and without notice. - Original instructions
To Next Page
Loading...
