EZ-IN
®
Series Turbine Flowmeter Manual
10
Installation
Precautions
The EZ-IN
®
Series Between-Flange Turbine Flowmeter can be installed
vertically or horizontally. In either orientation, the arrow on the meter body
must point in the direction of ow in the line.
Before installing the meter, clean all upstream lines.
Do not blow out lines with compressed air or gas once the meter has
been installed.
Do not slug the meter with uid. Carefully ll the line after installing
the meter. After startup, keep the meter full of uid.
Never exceed the minimum or maximum recommended pressure and
temperature limits. See Temperature and Pressure Ratings, page 25.
Never exceed the maximum recommended ow rate for the meter. See
Flow Ranges, page 25.
Avoid hammer blows or other sharp impacts to the meter that could
damage internal parts.
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
