EZ-IN
®
Series Turbine Flowmeter Manual
16
Reassembling the Hex-Body Meter
An arrow indicating direction of ow is cast or engraved on the meter
body, rotor, and vanes. When the meter is assembled, all arrows must
point in the direction that product will ow through the meter.
Vanes are designed to t into four notches inside the meter body.
During assembly, both vanes must be positioned such that the vane
blade marked with a ow arrow is closest to the bottom of the bore
(assuming that the conduit adapter is at the top of the meter).
Never use force when assembling meter components. The tungsten
carbide rotor shaft is brittle and can break under excessive force.
•
•
•
To Next Page
Loading...
Need help?
General
