Cameron Opti-Rip 415A-M1 - Table of Contents

Table of Contents
INTRODUCTION ...................................................................5
Company Introduction .......................................................................... 6
Limited Warranty ................................................................................... 7
Machine Requirements and Layout ..................................................... 8
RULES FOR SAFE OPERATION .........................................9
Types of Warnings .............................................................................. 10
General Safety Rules ...........................................................................11
Machine Safety Decals ....................................................................... 12
INSTALLATION ................................................................... 14
Receiving & Unpacking ..................................................................... 15
Opti-Rip Assembly .............................................................................. 16
Initial Placement........................................................................................... 16
Install the Belt Tracks .................................................................................. 16
Position the Roller Arms or Infeed Chains ................................................ 17
Install the Laser Stand ................................................................................. 17
Final Positioning .......................................................................................... 18
Position the Laser Stand ............................................................................. 18
Lag the Machine to the Floor ...................................................................... 18
Install the Lasers.......................................................................................... 18
Mount the Computer Stand ......................................................................... 19
Mount the Measuring Sensors .................................................................... 19
Connect Hoses and Wires ........................................................................... 19
Power Connection ....................................................................................... 20
Check Motor Rotation .................................................................................. 20
Movable Saw Connection (Optional) .......................................................... 20
Setting an Initial Saw Location ................................................................... 21
Set up a Simple Arbor ................................................................................. 21
Setting the Feed Delay ................................................................................ 21
Achieving Parallel Feed............................................................................... 22
Laser Setup .................................................................................................. 22
Final Alignment ............................................................................................ 23
Dismantling: ................................................................................................. 24
Machine Disposal: ....................................................................................... 24
OPERATION .......................................................................25
Safety & Training ................................................................................. 26
TABLE OF CONTENTS