58
TROUBLESHOOTING
TROUBLESHOOTING
#415-R1
8-15-18 - JR
Operational Troubleshooting
Nothing displays on the screen
The Machine feeds one board, then stops Make sure the Board Present light curtain
that is positioned between the pinch rollers
and the rip saw is operating properly. If the
sender and receiver are out of alignment, the
machine will "hang", waiting for the board to
nish feeding into the saw.
Boards aren't measured properly Go into the "Inputs and Outputs" window.
Hold something between the measuring
sensors while you press A on the keyboard.
The belts should move and the Sensor
Counts item on the screen should count
up. If it counts up whenever the belt moves,
regardless of whether the sensor beam is
broken, then the sensor transmitter and
receiver may not be aligned properly. There
are LED's on the sensor itself that indicate
when the sensors are aligned.
If boards are still being mismeasured, try
lowering the Accel value in the system
parameters so that the board moves more
slowly.
Press the Power button on the computer.
Check that the Power Adapter is working
properly.
Press and hold the z and Control keys while
pressing the Power button
To Next Page
Loading...