49
OPERATION
OPERATION
#415-R1
8-15-18 - JR
Memory Stick
Your Opti-Rip includes a memory stick. The Opti-Rip software uses this memory stick
(which must be named "Backup") to create an archive of your machine parameters, setups,
board data, etc. in case of system failure.
For protection, back up your system regularly. This is done by selecting "Backup to
Memory Stick" from the "Special" menu. The process can take a couple of minutes to
complete. Wait for the window that tells you that the les have been backed up.
The memory stick can also be used to transfer setups and board data from the machine to
an ofce computer or vice-versa.
Viewing Data Remotely
Your Opti-Rip software includes the ability to view certain production data from a web
browser. If Opti-Rip computer has been properly networked, you can access a general
report for the current setup by using the syntax:
http://10.0.0.75:21000/?report
A general report can be accessed for a specic setup number as well. For example, to
access setup #5, use:
http://10.0.0.75:21000/?report=5
You can also see the width distribution of the incoming lumber from various setups. To view
the current setup being used:
http://10.0.0.75:21000/?widthdist
For a width distribution for the lumber processed on setup #5:
http://10.0.0.75:21000/?widthdist=5
Note that the ip address shown in this example is the default ip address as assigned at
our factory. This may vary for compatibility with your local network. See your network
administrator for more information.
To Next Page
Loading...