●
1.6 Safety requirements and devices
The appliance is provided with the following safety devices:
Snap closure: the snap closure of the door folding into the frame when it stops and the special gaskets the door incorporates
make the firebox totally air-tight if compared to one without this device.
1.7 Environment requirements
WARNING: The installation of a "bipolar switch" is mandatory when providing the electrical connection of the fan-
assisted version; the bipolar switch acts as a safety device when the appliance is not operated or during
maintenance works as it enables to break the circuit and totally disconnect the appliance.
It is FORBIDDEN to disconnect the safety devices.
Note: This section has been drawn up considering the appliance as being operated in accordance with the
requirements and directions on the appliance use indicated under section 3.
Since Caminetti Montegrappa has no control over the conditions in which the appliance is being operated we
assume no responsibility for any injury or damage to people, properties or pets resulting from the non-observance
of these instructions and of the following recommendations:
A) During any maintenance, adjusting, cleaning and servicing works, the appliance must not be left unattended in
order to avoid incidental starting by third party.
B) Do not mishandle and/or remove any safety devices in the appliance.
C) Provide an efficient connection to the exhaust venting system.
D) Check that the room where the appliance is installed is aerated as prescribed.
IMPORTANT: To ensure its proper operation, the appliance shall be located in a ventilated room where an air flow allowing
the complete combustion of wood can be admitted according to the installation requirements under the local standards
currently in force.
The air supply must be sufficient for both proper combustion and to provide ventilation of the room, that is, no less than
15-20 sq.m.
The natural admission of air must be provided directly through two permanent openings made on the exterior walls of the
room of installation (for the section minimum dimension see section 2.3.5); the openings must be made in such a way they
can never be obstructed (check regularly).
Air entering the room where the appliance is installed from contiguous room(s) is permitted provided it is admitted from a
space which is aired directly from outside, a space which is not used as a bedroom or a bathroom and where fire ignition
could never occur, as in a garage or in a combustible warehouse, in compliance with the requirements under the local
standards currently in force.
80 cu.m/h of air is required in order to ensure proper fuel combustion.
(This pertains to operation with door closed).
Do NOT install the appliance in a bedroom or a bathroom, or in any other room where an existing heating appliance
(fireplace, stove, etc.) is not provided with its own outside air source.
It is FORBIDDEN to install the appliance near objects made of combustible materials (curtains, pieces of furniture,
carpets,...).
The appliance is not designed to be operated in environments where materials may explode. Therefore, it is
FORBIDDEN the use of the appliance in an explosive atmosphere or in a space where materials or machineries may
produce gas or dust emissions in such a quantity they may cause an explosion.
The minimum clearance to combustible side walls is 80 cm; a 150 cm clearance must be maintained to any objects or pieces
of furniture in front of the unit.
It is recommended that particularly delicate objects or pieces of furniture be installed at higher distances than those
previously recommended, if you assume they could be damaged by the changes in temperature produced during the
appliance operation.
The positioning of the appliance must be implemented in scrupulous compliance with the directions found in sections 2.3.
ENGLISH
TECH 3
16
To Next Page
Loading...