●
●
●
●
●
❍
❍
❍
❍
❍
●
2 INSTALLATION
2.1 Packaging dismantling and disposal
Consisting of non-toxic and not noxious materials, the packaging does not need any special disposal procedure; the user is in
charge of stocking, disposing of, or recycling the wastes of the packaging according to the regulations in force in the country
where the product has been purchased.
2.2 Installation requirements
The appliance must be installed in a space which allows to operate it and perform routine maintenance works easily. The room
chosen for the installation of the appliance must therefore feature:
Proper environment conditions and permanent outside air source as indicated under section 1.7 "Environment requirements".
A floor with proportionate load capacity (see appliance weight in section 1.3.2 of the manual).
230 V~ 50 Hz line voltage. (*)
Electrical system complying with the directives in force. (*)
* Only for forced convection models.
A system of exhaust gases complying with the standards in force aiming at guaranteeing:
Adequate draught for the correct and safe appliance operation.
Adequate resistance to high temperatures.
Adequate resistance to corrosion due to combustion products.
Easy access for periodic checks and maintenance.
Adequate insulation from inflammable materials.
The room must also comply also with further standards in force in the country where the appliance is installed.
2.3 Appliance installation
2.3.1 Making appliance lighter in order to facilitate handling
If the appliance needs to be installed in locations with limited access (for example, in upper floors or basements, and thus
accessible only through stairways), it is possible to lighten the appliance by removing the CMtech® parts and the flame distributor-
catalyzer in vermiculite.
This operation will reduce the overall weight for easier movement (see disassembly sequence in section 4.2.1).
Be sure to carefully and correctly put each CMtech® element back in place and also the flame distributor-catalyzer in vermiculite.
WARNING: Keep plastic coverings out of the children's reach as they could represent a danger.
IMPORTANT: All installation work for your appliance (insulation, electrical connections, input to chimney or flue,
installation of the accessories supplied with the unit, as well as any temporary removal and reinstallation of
appropriate component parts) must be performed only by qualified technicians or comparably experienced and
knowledgeable persons.
The same applies to the installation of our factory-built appliance cladding.
Caminetti Montegrappa assumes no responsibility for any incidental or consequential damage of any kind to
persons, pets or things resulting from the installation of a cladding that is not of our own production, or from the
inobservance of the prescriptions given in this manual.
ENGLISH
TECH 3
22
To Next Page
Loading...