Operating Instructions
Lubrication
This tool requires lubrication
before using the tool for the first
time and before each use. (fig. 6)
If an inline oiler is used, manual lubrication
through the air inlet is not required on a daily
basis.
1. Disconnect the air supply from the tool
to add lubricant.
2. Turn the tool so the air inlet is facing
up. (fig. 7)
3. Place 4-5 drops of 30 W non-detergent
oil into air inlet. Refrain from using
detergent oils, oil additives, or air tool
oils. Air tool oils contain solvents which
will damage the tools internal
components.
6 - Lubrication oil
Figure 7 - Insertion of oil
into nailer
To Next Page
Loading...
Need help?
General
