Campbell AVW200 series - 5. Device Configuration (DevConfig) Utility; 5.1 Connecting to DevConfig

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules
AVW200
FIGURE 4.5.2-1. AM16/32B to AVW200 Hookup (AM16/32Bs
controlled by datalogger and using SDI-12)
A CABLE4CBL-L cable is used to connect the multiplexer to the datalogger
(see Figure 4.5.2-2).
RES CLK GND 12V
O
N
MUXPOWER
SHIELD
CR800,
CR850
CR10X,
CR3000,
CR1000
CR23X,
CR5000
G G
CABLE
FIGURE 4.5.2-2. Multiplexer to Datalogger Power/Control Hookup
(multiplexer controlled by datalogger)
SHIELD
12 V 12 V 12 V
G G G
C1-C4 C1-C8 C1-C8
C1-C4 C1-C8 C1-C8
24