Campbell AVW200 series - 5.2 Deployment Tab

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules
FIGURE 5.1-1. Opening Page in DevConfig
5. Select the Serial Port matching the COM port on your computer in which
the AVW200 is connected.
6. Press the Connect button. The device may take up to 60 seconds to
respond to DevConfig, and for the current settings to be loaded into the
Settings Editor.
5.2 Deployment Tab
5.2.1 Communications
The Deployment Communications Editor is the active tab when you are first
connected (see Figure 5.2.1-1). These settings are used for RF
communications.
26