Appendix E. Status Table
Status
Fieldname
Description
User can change?
Rf_ForceOn When Rf_ForceOn is set to 1 the radio is always on
ignoring the duty cycle setting.
Yes
Rf_Protocol Identifies the radio protocol that will be used. The
AVW200 is always fixed at 2 (PakBus Aware mode)
Yes (changing this parameter to a
value of 1 will mess up the RF
communication). All other values will
revert to a value of 2.
RfSignalLevel The signal level of every 5
th
PakBus packet received
over RF
Yes (clear to zero)
RfRxPakBusCnt Number of PakBus packets that have been received
over RF communication
Yes (clear to zero)
RfPwrMode Radio power modes:
NO_RF (No Radio)
RF_ON (<24ma Always On)
RF_1/2_Sec (<4ma ½ Second)
RF_1_Sec (<2ma 1 Second)
RF_8_Sec (<0.4ma 8 Second)
RF_OFF (Radio Off)
Yes (ie to change from ½ seconds
duty cycle to 1 seconds duty cycle
mode, edit the parameter with:
RF_1_Sec
PortStatus(1) Indicates control port 1 level
0 = off (low zero volts)
-1 = on (high five volts)
No
PortStatus(2) Indicates control port 2 level
0 = off (low zero volts)
-1 = on (high five volts)
No
PortStatus(3) Indicates control port 3 level
0 = off (low zero volts)
-1 = on (high five volts)
No
PortConfig(1) Indicates control port 1 configuration (function
disabled reserved for future use).
Yes
PortConfig(2) Indicates control port 1 configuration (function
disabled reserved for future use).
Yes
PortConfig(3) Indicates control port 1 configuration (function
disabled reserved for future use).
Yes
MSPversion(1) MSP430 CPU #1 OS version No
MSPversion(2) MSP430 CPU #2 OS version No
MSPversion(3) MSP430 CPU #3 OS version No
MSPversion(4) MSP430 CPU #4 OS version No
MSPversion(5) MSP430 CPU #5 OS version No
MSPClkFreq(1) MSP430 CPU #1 RC oscillator frequecy in Hz No
MSPClkFreq(2) MSP430 CPU #2 RC oscillator frequecy in Hz No
E-2
To Next Page
Loading...