8-4 Receiving Faxes Chapter 8
Setting the Options for Fax/Tel Mode
If you set Fax/Tel Mode, you can control precisely how the machine handles incoming
calls by adjusting the following settings:
–
RING START TIME setting: Adjust the time the machine takes to check whether a call
is from a fax machine or from a telephone (default: 8 seconds).
– F/T RING TIME setting: Adjust the length of time the machine rings when the call is
from a telephone (default: 15 seconds).
– DEFAULT ACTION setting: Set whether the machine switches to receive mode or
disconnects the call after the ring time set in F/T RING TIME has elapsed (default:
switches to receive mode).
■ What Happens When Fax/Tel Mode is Selected
When the machine receives a call, it responds according to the type of call as follows:
Telephone
Fax
Fax
Sending document
manually
Sending document
automatically
The machine answers without ringing.
The machine listens for the fax tone.
(For 8 sec.)
The fax tone
is detected.
The fax tone is not detected.
The document is
received automatically
.
The machine starts ringing.
Pick up the
handset to talk.
If you do not pick up the handset
(within 15 sec.).
DEFAULT ACTION
Choose between:
RECEIVE (default setting) and DISCONNECT.
DISCONNECT
RECEIVE
(Default setting)
(The fax tone is detected
and the machine
switches to receive
mode.)
The machien
disconnects the call.
Not all fax machines are capable of sending the fax tone. If this is the case,
set the DEFAULT ACTION setting to RECEIVE so that the machine switches
to receive mode automatically and starts receiving the document. If no
document comes in, it disconnects the call after approximately 40 seconds.
F/T RING TIME
(Default setting
= 15 sec.)
Type of call
Telephone charges
begin for the caller.
RING START TIME
(Default setting
=
8 sec.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
