Handling sheets
Loading heavyweight paper in the Front Paper Feed Slot
Important
• Before loading heavyweight paper , change the media type setting to POP Board . After POP Board is
selected as the type of paper , you can select Front Paper Feed Slot .
• Always load a POP Board in the Front Paper Feed Slot . Loading it another way may damage the
printer or cause malfunction.
Note
• Y ou can load only one sheet of paper at a time.
• Store unused paper in the original package, away from high temperature, humidity , and direct sunlight.
• If the paper is warped, straighten it before loading it.
• Load the paper straight. Loading paper askew will cause an error .
• After loading the paper , you cannot move it laterally to reposition it. Be sure to load the paper straight.
1. If you send a print job specifying POP Board from a computer beforehand, the type and size of
paper are shown on the Display Screen . Press the Load/Eject button.
Note
• If you will load heavyweight paper before sending a print job, press the Load/Eject button. After a
menu for selection of the type of paper is shown on the Display Screen , press ▲ or ▼ to select POP
Board , and then press the OK button. Next, a menu for selection of the paper size is shown on the
Display Screen . Press ▲ or ▼ to select the size of paper , and then press the OK button.
2. If Leave 70cm (28") space behind printer . is displayed, check the space behind the printer , lift
the four Front T ray Guides on the Ejection Guide , and then press the OK button.
Note
• Suf cient space behind the printer is required when loading paper in the Front Paper Feed Slot . For
details on the space required for installation, see “Specications”. (→P .79)
150 Handling Paper
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General