2. Press the ▲ or ▼ button to enter the value.
Note
• Hold down ▲ or ▼ to increase or decrease the value continuously.
3. Repeat steps 1 and 2 to complete the settings, and then press the OK button.
Note
• If a confirmation message is displayed regarding the setting you entered, press the OK button. The
setting is applied, and the printer is now in Standby.
Executing menu commands
Menu commands can be executed as follows.
1. Press ▲ or ▼ to select the action to execute, and then press the OK button.
The menu command is now executed.
Menu Structure
The menu structure is organized by tabs, as follows. Values at right indicated by an asterisk are the defaults.
• Paper Menu →P.645
• Ink Menu →P.647
• Job Menu →P.647
• Set./Adj. Menu →P.648
For instructions on menu operations, see "Menu Operations." →P.642
For details on menu items, see "Menu Settings." →P.656
Paper Menu
First Level Second Level Third Level Fourth Level Fifth Level
Load Paper Roll Paper
Cut Sheet
Eject Paper
Chg. Paper Type
(*1 →P.647 )
Roll Paper (The paper type is displayed here.) (*1 →P.647 )
Cut Sheet (The paper type is displayed here.) (*1 →P.647 )
Chg. Paper Size Sheet Size (The size of paper is displayed here.) (*2 →P.647 )
Roll Length (*3 →P.647 )
Roll Width (*4 →P.647 )
ManageRemainRoll Off *
On
Paper Details (The paper type is
displayed here.)
(*1 →P.647 )
Head Height Automatic *
Highest
High
Printer Parts
>
Control Panel
>
iPF650 Menu Structure
8
645
To Next Page
Loading...
