Canon imagePROGRAF iPF650 - Roll Paper Is Not Securely in Contact with Roll Holder

Cause Corrective Action
Because paper expands or contracts
depending on the environment of
use, it may become narrower or wid-
er than the supported width for bor-
derless printing.
Select None when you have set Detect Mismatch in the Control Panel menu
to Warning.
However, note that this error may affect the printing quality.
The paper is loaded askew. Press ▲ or ▼ to select Fix Paper Position and straighten the paper so that the
edges are between the ink grooves for borderless printing.
Insert the roll firmly until it touches the flange of the Roll Holder.
(See "Attaching the Roll Holder to Rolls.") →P.568
Select None when you have set Detect Mismatch in the Control Panel menu
to Warning.
However, note that this error may affect the printing quality.
Press ▲ or ▼ to select Print With Border, and then press the OK button to
continue printing. The document will be printed with a border.
Roll paper is not securely in contact with roll holder.
Cause Corrective Action
When the roll was loaded, the roll was not in-
serted firmly all the way on the Roll Holder.
Follow these steps to reload the roll.
1. Press the OK button and remove the roll holder from the printer.
2. Insert the roll firmly on the Roll Holder until it touches the flange.
(See "Attaching the Roll Holder to Rolls.") →P.568
3. Load the Roll Holder in the printer.
Error Message > Messages regarding paper >
iPF650 Roll paper is not securely in contact with roll holder.
12
805