Canon imagePROGRAF iPF650 - GL2: W0502 the Parameter Is out of Range; GL2: W0504 this Command Is Not Supported; Gl2: Wxxxx the Memory Is Full. (XXXX Is 0501, 0903, Or); Messages Regarding HP-GL;2

Messages regarding HP-GL/2
This type of paper is not compatible with HP-GL/2. ........................................................................................ 814
GL2: Wxxxx The memory is full. (xxxx is 0501, 0903, or 0904) ...................................................................... 814
GL2: W0502 The parameter is out of range. ................................................................................................... 814
GL2: W0504 This command is not supported. ................................................................................................ 814
This type of paper is not compatible with HP-GL/2.
Cause Corrective Action
The printer has received a HP-GL/2
print job that cannot be printed on the
paper that has been advanced.
Follow these steps to replace the type of paper in the printer.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2. Replace the paper with a type compatible with HP-GL/2. For details on pa-
per compatible with HP-GL/2, refer to the Paper Reference Guide. (See
"Types of Paper.") →P.562
Press ▲ or ▼ to select Print, and then press the OK button to resume print-
ing. However, note that this error may cause paper jams and affect the print-
ing quality.
GL2: Wxxxx The memory is full. (xxxx is 0501, 0903, or 0904)
Cause Corrective Action
The printer memory is
full.
Because the entire print job could not be received, the printer may not be able to print the
entire original. Check the printing results.
GL2: W0502 The parameter is out of range.
Cause Corrective Action
A parameter specified in a HP-GL/2 command is out of the
supported range.
Check the print job.
If you have specified ProcessingOption > Warning
> On in the Control Panel menu, set it to Off in-
stead.
GL2: W0504 This command is not supported.
Cause
Corrective Action
The printer has received an unsupported HP-GL/2 com-
mand.
Check the print job.
If you have specified ProcessingOption > Warning > On
in the Control Panel menu, set it to Off instead.
Error Message > Messages regarding HP-GL/2 >
This type of paper is not compatible with HP-GL/2. iPF650
12
814