Basic Sending Methods
2-33
Sending Documents
2
In this step, the keys listed below are also available as needed.
NOTE
• For instructions on how to enter characters, see Chapter 2, “Basic Operations,” in the
Reference Guide.
• You cannot use group dialing for the Manual Sending mode.
6
When you hear a high-pitched tone, press (Start) to start
scanning your originals.
To cancel scanning, press [Cancel] or (Stop).
The scanned data is sent to the specified destination when scanning is complete.
4
Press [Scan Settings] to specify
the scan settings you require.
For more information, see Chapter 3,
“Specifying the Scan Settings.”
5
Enter the fax number (up to 120
characters) using -
(numeric keys).
If the number is registered in the one-touch
buttons, you can also press [One-touch
Buttons] to specify the number. (See
“Using the One-Touch Buttons,” on
p. 4-35.)
[Tone]: Press when you want to directly call an extension line that is
connected to a PBX (Private Branch eXchange), which accepts
only tone dialing. If you press [Tone], the letter <T> appears.
[R]: Press to use the R-key. (See “Calling from an Extension,” on
p. 2-51.)
[End]: Press to cancel the Manual Sending mode.
To Next Page
Loading...
General