Canon MF272dw - Page 53

Set the time zone (UTC
*1
) and Daylight Saving Time according to the region where this machine is installed.
*1 The UTC (Coordinated Universal Time) is a coordinated universal time that is standard for all parts of the
world. Internet-based communication relies on the UTC being set correctly.
2
On the [Current Time Set.] screen, enter the date and time, and press [Apply].
➠ The time and date ar
e set, and the Remote UI conrmation screen is displayed.
Step 3: Setting Remote UI
With Remote UI, you can use a Web browser on a computer to check the operation status of the machine, change the
settings, and perform other operations.
Set the System Manager ID and Remote UI Access PIN to prevent unauthorized access to the machine.
1
On the Remote UI conrmation scr
een, press [Yes].
2
Conrm the message, and pr
ess [Yes].
Restrict the use of Remote UI to only those users who know the Remote UI Access PIN.
3
Enter the Remote UI Access PIN, and press [Apply].
Specify any number. You cannot set a PIN consisting of all zeros, such as "00" or "0000000."
4
Enter the PIN again, and press [Apply].
➠ After the message [Settings congur
ed.] appears, and then the screen for conrming the wireless LAN
connection is displayed.
Step 4: Connecting to a Wireless LAN
Connect to the network using wir
eless local area network (LAN).
1
On the screen for conrming the wir
eless LAN connection, press [Yes].
● If the machine is not connected to a wir
eless LAN, press [No].
● When connecting to a wired LAN, congure the wired LAN connection settings after exiting the Setup Guide.
Selecting Wired or Wireless LAN(P. 50)
2
Select the Wireless LAN connection type, and connect to the Wireless LAN.
➠ The settings congur
ed in the Setup Guide are applied.
When you exit the Setup Guide, the [Home] screen is displayed.
[Home] Screen(P. 112)
Depending on your wir
eless LAN router, the connection type and security standards may vary. Check for a
connection type and security standard that are supported by both the wireless LAN router and the machine,
and then establish a connection according to the connection type. For the standards and procedure, see the
following:
Connecting to a Wireless LAN(P. 53)
Setting Up
44