Canon MVX150i User Manual (English)

Questions and Answers:

R
Richard BrownAug 10, 2025
How to fix Canon Camcorder that will not focus?
- C
  Crystal MoraAug 10, 2025
  If your Canon Camcorder is not focusing, make sure that it is set to CAMERA mode and that the power is on. Verify that a cassette is loaded. If the tape has reached the end, rewind it or replace the cassette. If the cassette is protected, replace the tape or change the position of the protect switch. Ensure the camcorder is set to CAMERA mode. If you're having trouble focusing on a particular subject, try focusing manually. Adjust the viewfinder with the diopter adjustment lever. Also, ensure that the lens is clean. Certain lighting conditions or loud sounds are not malfunctions.
C
Christopher PowellAug 20, 2025
Why are the buttons on my Canon MVX150i not working?
- K
  Kathleen SimpsonAug 20, 2025
  If the buttons on your Canon Camcorder aren't working, there are several potential reasons. First, ensure that the camcorder is powered on. If it is on, check whether a cassette is properly loaded. An exhausted battery pack can also cause this issue, so try replacing or charging it. Also, if the camcorder and wireless controller are not set to the same remote sensor mode, change the remote sensor modes. Finally, make sure that batteries of the wireless controller are not exhausted and replace them if needed. In some cases, the camcorder may have stopped operating to protect the tape; try unloading and reloading the cassette.
A
Andrea RodgersAug 30, 2025
What to do if playback button does not work on Canon MVX150i?
- R
  rsimpsonAug 30, 2025
  If pressing the playback button on your Canon Camcorder doesn't start playback, first ensure that the camcorder is turned on and set to PLAY (VCR) mode. Check that a cassette is loaded and, if the tape has reached the end, rewind it. Also, check the settings in the menu: make sure that [AV/PHONES] is set to [AV] and [AV / DV OUT] is set to [OFF]. Ensure that the TV/VIDEO selector on the TV is set to VIDEO. Adjust the volume with the selector dial if the speaker volume is turned off. Finally, stop playback/dubbing if you attempted to play back or dub copyright protected tape.