Restore Settings
8-19
8
Appendix
For dome case attachment, see the “Installation
Guide.”
Important
If the reset switch is pushed, network-related settings will also
be restored to factory default settings including the camera's IP
address, subnet mask, default gateway address, etc.
Accordingly, you can no longer operate the camera from the
PC you were using to connect to the camera before. When
initializing the camera, use the “VB Initial Setting Tool” installed
in your PC to set an IP address appropriate for the environment
in which the camera is used (See “Performing Initial Settings for
the Camera” (p. 2-6)).
Reset Switch
VB-M700F
VB-M600D
Reset Switch
VB-M600VE
Reset Switch
4
For VB-M600D/VB-M600VE, attach the dome case.
VB-M40
Reset Switch
To Next Page
Loading...
