-59-
Maintenance 5
Drive Train
• Stop engine and remove ignition key when servicing drive train.
• Allow machine to cool off before servicing. Engine and its ancillaries are very
hot after operation and may pose a burn hazard.
Tires
• Inate tires to the specied pressure. Under- or over-ination causes uneven
wear or other damages to tires.
• Dispose of drained oil properly.
Tire Size Pressure KPa(kgf/cm
2
)
CMX227 / CM226
Front Wheel AGR 4.00-7 (2PR) 120 (1.2)
Rear Wheel 17×8.00-8 (4PR) 240 (2.4)
CMX186 / CM185
Front Wheel AGR 3.50-7 (2PR) 110 (1.1)
Rear Wheel 16×7.00-8 (2PR) 110 (1.1)
5332M-0507-010E
Valve Cap
1. Park machine on a level ground.
2. Remove valve cap.
3. Check tire air pressure. If different from the
specied values, adjust pressure.
4. Put valve cap back in place.
To Next Page
Loading...
